Badge Installation Question

Need help? Want to help? Discuss technical issues and share tips.
User avatar
artgod
Posts: 11
Joined: Tue Mar 12, 2013 10:22 am
Location: Montclair VA
Contact:

Badge Installation Question

Postby artgod » Sun Apr 07, 2013 11:57 pm

I have two new badges to install on my scoot. They have metal posts out the back and I have read, to do this correctly, I trim down the post to about 1/8" and then pound so they flar out. Is this correct?

I've also seen then with little black clips on the back but I can't find those, and don't know what they are called so its hard to search for them. I would like to use this option because I'm less likly to jack up my paint job.

Anyone have any advice?
My Current Restoration Photo Album on my 50 Special

dirtyhandslopez
Posts: 876
Joined: Thu May 01, 2008 1:12 am
Location: Richmond, VA.

Re: Badge Installation Question

Postby dirtyhandslopez » Mon Apr 08, 2013 12:59 pm

Either go to a hardware store, badge in hand, and find something that fits or buy some from a scooter specific shop. The store you bought the badges from should have them.
That's not going anywhere


Return to “Service Center”

Who is online

Users browsing this forum: No registered users and 4 guests