Need help? Want to help? Discuss technical issues and share tips.
4 posts • Page 1 of 1
So what is anyone here rocking on the rear of the their smallframe? I've got a Michelin S1 3.00J - 10 which is rubbing on the exhaust manifold coming off of the engine. I need only a few more millimeters of clearance and I'll be fine. I thought the S1s would work, but is there another size that's slightly less tall that will work or should I get something other than an S1 on there.
So I managed to loosen the cylinder shroud and got at the 2 bolts holding the manifold on. There's a lot of wiggle room on the two studs that the manifold mounts on, so I was able to just push it up as I torqued it back down and got the room I needed.
Who is online
Users browsing this forum: No registered users and 1 guest